PAGE 2 OF 6
0621 IH-2127
ASSEMBLY
1. Verify all parts are present before beginning.
Hardware is located in a white box.
2. Flip the tabletop upside down. Take one leg at a
time and loosely attach the end of the leg to the
tabletop using one bolt, two washers and one nut.
The leg braces are an inside mount. The legs are
labeled left and right. Match the legs to the left and
right markings on the underside of the table.
(See Figure 1)
3. Insert the cross brace with the umbrella
holder facing upward and loosely bolt to the
corresponding corners using one bolt, two washers
and one nut. (See Figures 2a-b)
4. Flip the table upright and loosely attach the four
bench seats to the legs using two hex head bolts,
two nuts and four washers per leg. (See Figure 3)
5. Ensure the tabletop and bench seats are level, then
tighten each bolt, finishing with the cross brace.
NOTE: H-2300 mounting hardware is sold
separately.
Figure 3
1-800-295-5510
uline.com
Figure 2a
Cross Brace
Table Leg
Figure 1
Right Leg
Left Leg
Figure 2b
Cross Brace
underside
of table
