PAGE 2 OF 18
1122 IH-2043
HARDWARE
Bundle of Wire with Pre-wired
Ring Terminal x 1
5/16" Pre-wired Jack x 2
Cable Tie x 4
1/4 x 2¾" Hex
Head Bolt x 4
3/16 x 2¼" Flat Allen
Head Bolt x 2
1/4 x 3/4" Hex
Head Bolt x 6
3/8 x 1" Allen
Head Bolt x 12
5/16 x 2½" Hex
Head Bolt x 1
3/16 x 2¾" Flat Allen
Head Bolt x 2
ASSEMBLY
FRAME
1. Loosely attach front and back rail to leg assemblies
using stud plates and 1/4" locknuts. Ensure the
rail side with four holes is facing the top of the
workbench. (See Figure 1)
IMPORTANT! Ensure front and back rails are
flush with the top of leg assemblies and
pushed inward approximately 1/8" to allow
bench top to be mounted properly.
2. Secure lowest holes in back rail to leg assemblies
with 1/4 x 3/4" hex head bolts and 1/4" flat washers.
3. Tighten all nuts and bolts. (See Figure 1)
Figure 1
1/4"
Locknut
1/4 x 3/4" Hex
Head Bolt
1/4" Flat
Washer
1 x 3⁄"
Stud Plate
2 x 2" Stud Plate
Front Rail
Back Rail
Footrest Guard Tape x 1
5/16" Serrated
Washer x 1
5/16" Flat Washer x 3
(2 thin, 1 thick)
1/4" Flat Washer x 22
1/4" Finish Washer x 4
Ring Terminal x 3
2 x 2" Stud Plate x 2
1 x 3⁄" Stud Plate x 2
3/16" Lock Washer x 4
3/16 x 3/8" Round
Head bolt x 4
1/4" Locknut x 8
3/4" Wood Screw x 25
3/16 x 2⁄" Round
Head Bolt x 4
3/16" Cap Nut x 4
3/16" Locknut x 4
Self-Adhesive Pad x 4
1/4" Strut Nut x 4
3/8" Strut Nut x 12
End Cap x 4
3/16" Nut x 4
5/16" Nut x 3
(2 thin, 1 thick)
