PAGE 2 OF 6
0713 IH-1555-10
StEP 1: FRAME ASSEMbLy CONtINuED
2. using 3/8-16 x 1¼" hex head cap screws &
self-locking nuts, bolt the top (slotted hole) of
back panel (F) to the insides of L1. (See Figure 1)
3. bolt the bottom (round hole) of back panel (F) & back
of base panel (E) to the insides of L2.
4. bolt the front of base panel (E) to the insides of L3.
(See Figure 1)
StEP 2: HORIZONtAL AND VERtICAL
bRACE ASSEMbLy
noTE: do noT tighten bolts until instructed to.
1. using (3) 3/8-16 x 1¼" hex head cap screws, locate
horizontal brace (G) on the outside of L4 & L5.
2. Locate the vertical brace (H) on the outside of L4 & L6.
3. Start (2) self-locking nuts onto screws at L5 & L6.
WARnInG! never climb a ladder that is not
completely assembled.
StEP 3: DIAGONAL bRACE ASSEMbLy
noTE: do noT tighten bolts until instructed to.
1. Locate diagonal brace (I) on the inside of L4 using
existing screw from Step 2, #1 and #2. Start locknut.
(See Figure 1)
2. using the screw installed at Step 1, #2, locate other
end of diagonal brace (I) on the inside of L2 and
start locknut.
3. Repeat step 2 and 3 to other side.
Figure 1
ASSEMBLY ConTInUEd
Figure 2
StEP 4: INStALL HANDRAILS
noTE: do noT tighten bolts until instructed to.
1. With ladder on its side, install handrail (A) into the
rear stile tubes. use the rubber mallet as needed for
mating parts. (See Figure 2, Step 1).
2. Clamp side handrails to outside of stile tubes using
handrail brackets and 3/8-16 x 2" hex head cap
screws and self-locking nuts. (See Figure 2, Step 2)
3. Repeat step 3 with side handrail (b).
STEP 2
STEP 1
STEP 3
1/4-20 x 23⁄4"
H.H.C.S.
HANDRAIL
HANDRAIL
BRACKET
3/8-16
SELF-LOCKING
NUT
3/8-16 x 2"
H.H.C.S.
NOTCHED
BUSHING
SIDE
HANDRAIL
STILE
TUBES
REAR STILE
TUBE
HANDRAIL
TUBE CAP
REAR
HANDRAIL
BAR
C
D
A, B
L1
L1
I
H
E
D
G
F
L4
L6
L3
L1
L5
L2
SINGLE HOLE
MODEL
DOUBLE HOLE
MODEL
L3
L3
SINGLE HOLE
MODEL
DOUBLE HOLE
MODEL
