PAGE 2 OF 6
0421 IH-1364
Round
Pin
Axle
NOTE: Do not use air or power tools.
ATTACH HANDLE
1. Slide handle into the handle brackets on the
back side of the frame. Align holes in handle and
brackets. If handle won't slide in, loosen bracket
bolts. Insert four hex washer head bolts through
brackets and handle and secure with locknuts.
(See Figure 1)
ATTACH NOSE PLATE AND AXLE SUPPORTS
1. Position frame reinforcements against bottom frame
rail. (See Figure 2a) Slide nose plate into channel
on frame reinforcement, keeping bolt holes aligned.
(See Figure 2)
2. Align axle support with outside rail of frame.
(See Figure 2)
3. Insert four 8mm bolts through the axle supports,
frame, frame reinforcements and nose plate. Secure
with locknuts but DO NOT tighten. (See Figure 2)
ATTACH AXLE AND WHEELS
1. Lay hand truck down on front so axle supports face
upwards. (See Figure 3)
WARNING: If installing stair climber, refer to
instructions included with stair climber and skip
step 2. Once complete, continue with step 3. If
not installing stair climber, continue to step 2.
2. Insert axle through holes in axle supports. Align holes
in axle with grooves on inside of the axle supports.
Use a hammer to tap in the round pins. (See Figure 3a)
3. Slide a spacer onto each end of the axle. Slide a
wheel onto each end of the axle. Slide a washer
onto each end of the axle. (See Figure 4)
4. Insert a cotter pin through the holes in each end
of the axle. Bend cotter pins using pliers to secure
wheels. Wheels should spin freely. (See Figure 4)
5. Tighten all locknuts.
6. Check tire pressure (30 psi max). Inflate if necessary.
ASSEMBLY
Figure 3
Figure 4
Frame
Frame
Reinforcements
Figure 2
Figure 1
Figure 2a
Figure 3a
1-800-295-5510
uline.com
