PAGE 3 OF 15
0321 IH-1106
ASSEMBLING CABINET
1. Place the back (1) on a protected surface.
The bottom flange should be facing upward.
(See Figure 1)
NOTE: When bolting the unit together, leave
the bolts slightly loose until step 7, unless
otherwise instructed.
2. Attach the left side (2) to the back by placing
flange around the back, and bolting the back
and side together with four bolts and nuts. Be
sure that the lances on all shelf adjustment strips
point in the same direction. (See Figure 2)
3. Attach the top (7) to the unit by sliding the outer
flange over the back of the unit and the side flange
to the side panel on the unit. The threaded studs
should go through the holes in the top flange of the
side and fasten with three nuts. Attach the back to
the top using four bolts and nuts. (See Figure 3)
4. Attach the right side (3) to the back in the same
manner as done in step 2, again making sure that
the flange is around the back and that the lances
on the shelf adjustment strips are pointed
in the same direction as those on the back and
left side. Push the right side panel up so the studs
in the top go through the holes in the top flange of
side and fasten with three nuts. (See Figure 4)
5. Attach the sill (4) to the sides. Place nut loosely on
each of the studs and slide the ends of the sill into
the slots on both sides on the unit. Then securely
tighten the nuts. (See Figure 5)
ASSEMBLY
Flange goes
under back
All lances point
UP on both back
and side.
2
Figure 2
Figure 4
3
7
Figure 3
Nuts placed loosely
on studs of the sill.
Slide ends into the slots on
the bottom of the sides.
4
Figure 5
Flange faces upward
1
Figure 1
