0513 IH-1027
PAGE 3 OF 11
safety InstrUctIons contInUed
loadIng tHe stapler
1. Disconnect the air supply.
2. Pull the pusher back until it stops on pusher pivots.
Rotate pusher to position. (See Figure 1)
3. Insert 2 sticks of appropriate staples into the
magazine. Let the sticks slide forward to the front of
the magazine. (See Figure 2)
4. Pull the pusher back to an upright position and
gently let the pusher slide forward against the
staples. Do not let the pusher slide forward and strike
the staples at high speed as this may deform the
staples and damage the stapler.
staple leg lengtH
1. Loosen the set screw on the bottom with a 3 mm
Allen wrench. (See Figure 3)
2. Adjust L/S screw with a screwdriver to the desired
setting. (See Figure 4)
a. If you are using ¾" staples set L up.
b. If you are using ⁄" staples set S up.
(See Figure 5)
3. Tighten the set screw on the bottom.
Pusher
L
Figure 1
Figure 3
Figure 4
Figure 5
Figure 2
Set Screw
L /S Screw
