PAGE 4 OF 5
0818 IH-2607
Optimal energy efficiency 100% of the time – in use and out of use.
• Saves energy in four ways: energy efficient electronics, jam prevention,
standby mode and sleep mode.
• Sleep mode shuts down shredder after two minutes of inactivity.
18
1. In sleep mode.
2. To get out of sleep
mode, touch control
panel.
ENERGY SAVINGS SYSTEM
PRODUCT FEATURES CONTINUED
3. Insert paper.
18
or
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensor are for maintenance-free
operation. However, on rare occasions the sensors may
become blocked by paper dust, causing the motor to
run even when there is no paper present.
NOTE: Two paper detection sensors are located
in the center of the paper entry.
18
18
1. Turn off and
unplug shredder.
2. Locate auto-start
infrared sensor.
3. Dip cotton swab
in rubbing alcohol.
4. Using cotton swab, wipe away any
contamination from the paper sensors.
MAINTENANCE
18
1. Apply oil
across entry.
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and
could ultimately stop running. To avoid these problems,
we recommend oiling shredder each time user empties
waste bin.
CAUTION! Use only a non-aerosol vegetable oil
in long nozzle container, such as S-16094.
Follow oiling procedures below and repeat twice.
2. Press and hold Forward ( )
for two to three seconds.
