CO2175FF
,
2175RF
13
Ice Cube Thickness Adjustment
Interval - As Required
On ice maker equipped models, the cube size may be
adjusted by changing the amount of water injected into
the ice maker assembly as follows:
Figure 11
1. Remove the ice maker assembly cover
(Figure 11)
.
Figure 12
2. Locate the adjusting screw on the ice maker assembly
control box. The adjusting screw is just below the minus
(-) and plus (+) signs on the control box
(Figure 12)
.
NOTE:
Make adjustments in small increments. Too
large of an adjustment could cause the unit to
malfunction.
CAUTION
Too large of an adjustment to the screw can cause
the water to overflow the ice maker and can cause
property damage.
3. Turn the adjusting screw toward the minus (-) sign
(clockwise) for smaller cubes or toward the plus (+) sign
(counterclockwise) for larger cubes.
4. Install the ice maker assembly cover.
IMPORTANT
IMPORTANT
Use only genuine U-Line replacement parts. U-Line
ice maker parts are not the same as standard FSP
Whirlpool parts. Using non U-Line parts can reduce
ice rate, cause water to overflow from ice maker
mold, damage the unit, and may void the warranty.
Leveling
It is important that units equipped with adjustable feet
are level, for proper door and ice maker (if equipped)
operation.
To level units with adjustable feet:
Figure 13
1. Use a level to check the levelness of the unit from
front to back and from side to side. Level should be
placed along top edge and side edge as shown
(Figure 13)
.
Figure 14
2. If the unit is not level, adjust the feet on the corners of
the unit as necessary
(Figure 14)
.
3. Check the levelness after each adjustment and repeat
the previous steps until the unit is level.
ULIN_0273_A
ULIN_0056_A
ULIN_0193_A
1
1
ULIN_0042_A
