www.U-LineService.com
2
04/2006
Installation Instructions
Removing Existing Door
1. Remove the door shelves by first pulling shelves up at
a 45° angle, then straight out.
2. Remove top hinge screw pin (Phillips screwdriver).
Remove the door by tilting forward and lifting off the
bottom hinge pin.
3. Pull door gasket out of the groove (top edge of door
only). Start in the middle and pull outward, moving
toward the edge (see
Figure 1
). This may take some
force.
4. Remove the two screws located on both sides of the
handle.
5. Remove the door panel from the door.
6. Discard the old door.
Preparing the old panel for the new door:
1. Remove the existing metal panel backer.
2. Remove the existing L-shaped angle bracket in the top
corner.
3. Modify the notch in the top corner of the door. The
width needs to be changed to 1" (see
Figure 3
).
4. Create an identical notch in the bottom corner of the
door, directly under this notch - 1" wide by 1/8" high by
3/4" deep (see
Figure 4
).
Attaching the Full Overlay Panel
1. Place and tape the existing door panel on the back of
the overlay panel (see
Figure 5
) and drill holes
through both panels according to
Figure 6
. Remove
tape adjoining the panels and enlarge the six holes in
the overlay panel using a 0.201" (#7) drill.
2. If a user-supplied cabinet handle will be used, attach its
hardware to the overlay panel at this time.
New Handle
Old Handle
ULIN_0403_A
Figure 1
Figure 2
ULIN_0358_A
Remove this
Material
Old
New
Figure 3
1"
3/4"
1/8"
ULIN_0363_A
Figure 4
Removed
Door Panel
Bottom of
Wood Panel
Back of
Wood
Panel
Side of
Wood Panel
Tape
7/16"
Bottom
3/8"
Both Sides
Figure 5
28-7/8"
1.5"
1.5"
±
1/4"
16"
3"
Drill ø 5/32" x 3/8" Deep
7 Places Model 2175
6 places Model 2115 and CLR2160
For use with #10 x 5/8"
Wood Screw and Nylon Spacer
12.25"
For use on
Model 2175 Only
ULIN_0365 _A
Figure 6
