PAGE 2 OF 4
1114 IH-4709
GENERAL DESCRIPTION
H-4709 and H-4710 pallet trucks lift and transport loads
on rigid forks.
Controls for steering, braking, forward and reverse travel,
horn, lift, lower and speed control are all located on the
control handle.
NAMEPLATE AND WARNING DECAL
Nameplate and warning decal locations may vary
between models, but they are always near the steering
arm, within sight of the operator.
(See Figure 1 for H-4709 and Figure 2 for H-4710)
If the name plate or warning decal are lost or
damaged, they should be replaced immediately. Have
your supervisor or the designated authority contact
Uline for replacement.
The name plate shows the model number, serial number,
truck type, battery type, voltage, minimum weight and
information on load capacity and load center.
The warning decal contains warnings that also appear
in this manual.
WARNING! This truck is equipped with a battery.
Read and heed the warning decal located
near the battery. An example is shown here:
LOAD CAPACITY
Do not overload truck. Check capacity plate for load
weight and load center information.
The load capacity depends on the load center. The
load maximum capacity listed on the capacity plate
assumes a uniform load whose center is at 1/2 the
length of the fork and centered between the forks.
The maximum load capacity is reduced when the
load center exceeds 1/2 the length of the forks or is
not centered between the forks. The fork length and
wheelbase must be adequate for the skid or bin to be
handled. (See Figure 3)
NOTe: A truck undergoing speed changes is less
stable than a standing truck. If you are not sure
that the truck can lift a certain load, consult your
supervisor or the designated authority.
GeNeRAl INfORmATION
Length of Forks
Load Center
1/2 Length
Figure 3
Name Plate
Warning Decal
Figure 1
H-4709
Name Plate
Warning Decal
Figure 2
H-4710
