U-Line ADA24R, Инструкция по использованию и уходу

Страница: 13 / 20

ADA24 11
ADA SERIES
Figure 15
5. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge (Figure 15) . Do not
install hinge on cabinet at this time.
Figure 16
6. Remove bottom hinge from cabinet (four screws) and
screws on opposite side of cabinet (Figure 16) .
7. Remove pivot screw from bottom hinge, invert screw
and reinstall pivot screw in hinge (Figure 15) .
Figure 17
8. Install bottom hinge on cabinet, opposite side, aligning
flat edge of hinge with outer edge of unit (Figure 17) .
Partially tighten screws.
Figure 18
9. Relocate plastic spacer/bushing (Figure 18) on bottom
of door to the opposite side. Clean out bushing hole in
door bottom if necessary.
Figure 19
10. Place door on lower hinge pin. Align flat edge of top
hinge with outer edge of unit and fasten upper hinge
to unit (four screws)
(Figure 19) . Partially tighten
screws until door is aligned.
11. Adjust door to assure proper seal. Tighten upper and
lower hinge screws securely.
12. Replace four plastic plugs removed in Step 4 into holes
on top of unit. Replace screws in holes in bottom of unit
on opposite side.
13. Replace the grille.
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
ULIN_0106_A
ULIN_0107_A
ULIN_0160_A
1
ULIN_0109_A
ULIN_0110_A