U-Line 75F, Инструкция по использованию и уходу

Страница: 8 / 16

8 75F
General Cleaning
Exterior Cleaning (As Required)
Black and White Models:
• Surfaces may be cleaned with a mild detergent and
warm water solution. Do not use solvent-based or
abrasive cleaners. Use a soft sponge and rinse with
clean water. Wipe with a soft, clean towel to prevent
water spotting.
Interior Cleaning (As Required)
• Disconnect power to the unit. Clean the interior and all
removed components using a mild non-abrasive
detergent and warm water solution applied with a soft
sponge or non-abrasive cloth. Rinse the interior using a
soft sponge and clean water.
• Do not use any solvent-based or abrasive
cleaners. These types of cleaners may transmit
taste to the interior products and damage or
discolor the interior.
Maintenance
Proper maintenance of your U-Line product will ensure
efficiency, top performance and long life. The
maintenance intervals listed are based on normal
conditions. You may want to shorten the intervals if you
have pets or other special considerations.
Defrosting
Manual Defrost Models - Every Two Months
(Minimum)
WARNING
DO NOT use any type of electrical heating device,
ice pick, knife or other sharp instrument to
defrost; this could damage the inner lining or
refrigeration system and void the warranty.
Figure 4
To defrost:
1. Turn unit off.
2. Remove all products from the interior.
3. Remove all glass shelving from unit. Allow glass to
acclimate to room temperature, then clean and set
aside to reinstall after defrosting unit.
4. Prop the door in an open position (2" (5 cm) minimum).
5. Allow the frost to completely melt naturally. Clean the
interior and all removed components using a mild non-
abrasive detergent and warm water solution applied
with a soft sponge or non-abrasive cloth.
NOTE: DO
NOT use any solvent-based or abrasive cleaners. They
will discolor or damage the interior.
6. Dampen a soft sponge or non-abrasive cloth in clean
water and wipe down the cabinet interior and removed
components to remove any detergent residue. Rinse the
sponge or cloth in clean water and repeat as necessary
until the cabinet and components are clean.
7. When the interior is dry, reinstall glass shelving, making
sure back strips are attached on back edge of glass fully.
Then slide glass back into unit fully and turn unit back
on.
6 Cleaning and Maintenance
ULIN_0231_A
ULIN_016357_30144.fm Page 8 Tuesday, March 14, 2006 2:34 PM