ODIN-W2 series - Data Sheet
UBX-14039949 - R05
Advance Information
Qualification and approvals
Page 28 of 36
In accordance with 47 CFR § 15.19 the end product shall bear the following statement in a conspicuous location
on the device:
"This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation."
When the device is so small or for such use that it is not practicable to place the statement above on it, the
information shall be placed in a prominent location in the instruction manual or pamphlet supplied to the user
or, alternatively, shall be placed on the container in which the device is marketed. However, the FCC ID label
must be displayed on the device.
In case, where the final product will be installed in locations where the end-user is not able to see the FCC ID
and/or this statement, the FCC ID and the statement shall also be included in the end-product manual.
7.5
Japan radio equipment compliance
The ODIN-W2 series modules are in Advance Information status as mentioned in Document status
section. Hence, the information in this section is not fully valid and completed yet but will be
when the module is fully tested and approved in the Production Information stage as mentioned
in the Document status section on page 2.
The ODIN-W2 module complies with the Japanese Technical Regulation Conformity Certification of Specified
Radio Equipment (ordinance of MPT N°. 37, 1981), Article 2, Paragraph 1:
•
Item 19 "2.4 GHz band wide band low power data communication system"
•
Item 19-3 “Low power data communications system in the 5.2/5.3 GHz band”
•
Item 19-3-2 “Low power data communications system in the 5.6 GHz band”
The ODIN-W2 module is restricted on the Japanese market to be used indoors only if the product is operating in
the 5.2/5.3 GHz band. The information: “Indoor use only” translated into Japanese
(
この製品は屋内においてのみ使用可能です
) must be visible:
•
on the certified end product.
•
on the product package in which the end product is marketed.
•
in the users / installation manual of the end product.
The indoor usage information is recommended to be printed close to the Giteki mark but it is also permitted to
place that information on another prominent position.
The ODIN-W2 MIC certification number is 204-510009.
The very small size of the module makes it not reasonable to fit the GITEKI mark and certification number
onto the module label. Instead the Giteki mark and certification number is available in the
ODIN-W2 series
System Integration Manual [2]
and on the ODIN-W2 package.
When a product integrated with an ODIN-W2 module is placed on the Japanese market, either must:
•
the ODIN-W2 module be affixed with a label with the Giteki marking below.
In this case is it recommended that the product is marked with “Contains MIC ID:
R
204-510009”.
•
the product be affixed with a label with the Giteki marking below. The marking must be visible for
inspection.
