EVK-NINA-W1/EVK-NINA-B2 - User Guide
UBX-17011007 - R05
Setting up the evaluation board
Page 14 of 21
o
Download the GIT repository provided by Espressif
•
Setup Path to ESP-IDF
o
The tool chain program can access the ESP-IDF using the IDF_PATH environment variable
•
Build and Flash
o
Start a Project, Connect, Configure, Build and Flash a program
More information about this is available at http://esp-idf.readthedocs.io/en/latest/index.html
More information on this topic can be found in the NINA-W1 System Integration Manual [7].
2.2
EVK with u-blox connectivity software
This section is applicable for the following EVKs:
•
EVK-NINA-B221
•
EVK-NINA-B222
•
EVK-NINA-W131
•
EVK-NINA-W132
•
EVK-NINA-W151
•
EVK-NINA-W152
2.2.1
Starting up
Perform the following steps to enable communication with the module:
1.
Start the u-blox s-center evaluation software.
2.
Use the default baud rate 115200, 8N1 with flow control. Now, it is possible to communicate with
the module through AT commands.
For a list of available AT commands, see the u-blox Short Range AT Commands Manual [5].
2.2.2
Getting the latest software
Go to the u-blox support web page to obtain the latest available software. Instructions on reflashing
the evaluation board can be found in the Software section of the NINA-B2 System Integration Manual
[8] or the NINA-W1 System Integration Manual [7].
