EVK-ANNA-B112 - User Guide
UBX-18018539 - R01
Setting up the evaluation board
Page 20 of 29
2
Setting up the evaluation board
2.1
Evaluation board setup
The EVK-ANNA-B112 will be delivered with u-blox connectivity software installed.
Before connecting the module, download, and install the latest u-blox s-center evaluation software
from the u-blox website.
To use Bluetooth Low Energy on the EVK-ANNA-B112, connect a 2.4 GHz antenna to the U.FL
antenna connector (J10). The EVK-ANNA-B112C has an onboard antenna.
Plug in either an external power supply in J5 connector or connect to a USB host with a USB cable
attached to J8 connector. You can also power the evaluation board with a CR2032 coin cell battery.
The status light (
DS6) will turn green, indicating it has power. The NFC antenna can be connected to
the J11 connector. Both ways of board connection are possible, rotation of 180 degrees.
⚠
Be careful to check polarity before connecting an external power supply to the EVK-ANNA-B112
evaluation board. Center conductor is positive (+) and the ring is negative (-).
The very first time you connect the unit to a new computer, drivers need to be installed. The
operating system should handle this automatically.
⚠
If the drivers are not installed automatically, download the nRFgo Studio from
www.nordicsemi.com
to get the Jlink CDC UART driver.
A COM port will automatically be assigned to the unit by Windows. Do the following to view the
assigned COM ports on Windows 7:
•
Open the Control Panel and click Hardware and Sound.
•
Click Device Manager in Devices and Printers. This will open Device Manager window where you
can view the assigned COM ports.
2.2
Starting up
2.2.1
EVK-ANNA-B112
Perform the following steps to enable communication with the module:
1.
Start the u-blox s-center evaluation software.
2.
Use the default baudrate 115200, 8N1 with flow control.
3.
You will now be able to communicate with the module through AT commands.
For a list of available AT commands, see the u-blox Short Range AT Commands Manual [3]. To get
started with a basic use case setup of the EVK-ANNA-B112 with u-blox connectivity software, see the
ANNA-B112 Getting Started [5].
2.2.2
EVK-ANNA-B112 SDK
If you would like to use the EVK-ANNA-B112 together with the Nordic Semiconductor SDK, refer to
the Software section of the ANNA-B112 System Integration Manual [2].
2.3
Getting the latest software
Go to the u-blox support webpage to obtain the latest available firmware. Instructions on flashing
the EVK-ANNA-B112 can be found in the Software section of the ANNA-B112 System Integration
Manual [2].