TYROLIT Hydrostress TME1000P, Руководство по эксплуатации / Список запасных частей

Страница: 11 / 18

11
3. Assembly and initial preparation for operation
3.1 Assembly tools
• Combination wrench size 13/46
3.2 Setup
Danger! • Put the saw on a clean and horizontal ground
• Press the parking brake (ltem 15)
3.3 Installation of the saw blade (or checkinq the installation)
Notice! • High adjustment must be tighten
• Water hose coupling is open
• Remove the hexagon bolt
• Turn the saw hood forward on the table
• Remove the flange nut (left-hand thread) and thrust washer .
ATTENTION! When installing the saw blade, observe the following:
• All receptacle surfaces must be clean .
• Rotation direction arrow on the saw blade must match the one on the hood .
• Use only diamond saw blades intended by the manufacturer.
• lnstall thrust washer and flange nut. (Combination wrench size 13/46)
• Turn back the saw hood
• Fix the saw hoos with the hexagon bolt
• Close the water hose coupling
3.4 Saw preparations
• Fill the pan with water until the pump is submerged.
• Open the water valve.
• Plug the supply line cable (400 VI 32 A) into the socket (item 8) .
• Check protective equipment (see 2.2) .
• Switch the main switch (item 3) to “I ON”.
3.5 Test direction of rotation of the saw blade
• Turn Star delta switch (item 1) to “star”.
• Press button start (item 2).
• Turn star delta switch (item 1) to “0”.
• Check the direction of rotation of the saw blade.
*
The direction of rotation is clockwise, seen from the left
(direction arrow on the saw hood) .