typical GC2605, Инструкция по эксплуатации и каталог запасных частей

Страница: 6 / 44

Hinge
A
Fig.2
Model GC 2605 cylinder bed compound feed
binding sewing machine is constructed with single
straight needle, link thread take-up with needle bearing,
precise spiral bevel gear transmition, big rotating hook
withdouble capicity and forward or reverse sewing. It has
the advantages of stable motion, small moment of force,
low noise, beautiful plat stitches in appearance. It is
widely used in the factories of garments, leather goods,
suits & case, and others.
.
-1-
1. B r i ef i nt r oducton i
2. M ai n S peci f i cat i ons
1) Max. sewing speed: 2,000spm
2) Max. stitch length: 6mm
3) Presser foot lift: 6.5mm(13 mm by knee)
4) Max. Sewing thickness: 8mm
5) Needle: Model DP
×
17 Nm110~180
6) Rotating hook: big rotating hook with
double thread capacity
7) Motor: 370w (special for sewing
machine)
3. I nst al l at i on a nd p r epar at i on
3.1 Installaion
3.1.1 Location or the machine
The machine must be located on rigid and flat floor
for ensuring its smooth motion and reducing its vibration.
Furthermore, a rubbermat should be inserted into between
the machine stand and the floor for further. reducing the
running noise.
3.1.2 Mounting the base of the machine head
First of all the knee lifter pushing rod screw will
be set into the table and Nut 3 will be fastened (see Page
32).
Then the four screw holes of the base will be made to
align the four holes of the table and should be plunged
through four bolts and will be fastened. The knee liner
pushing rod B should be inserted into the position hole
of the base (Fig.1),adjusting the base to make rod B insert
it freely. Finally the four bolts will be fastened again.
3.1.3 Mounting the machine head (Fig.2)
At first, halt of the hinge should be made to engage
with the base of the head, then put the head lightly on the
base of the head and movfing slightly. The three screw
holes of the hinge of the head shall be made to align with
the three holes of the hinge and the three screws will be
fastened and fixed.
3.1.4 Mounting the rock shaft bracket of knee lifter (Fig.
3,also see figure on page 32)
1) Adjust rock shaft plate 18 according to the body
of the operator, ensuring easy operation, light force and
proper swing angle.
2)Adjust the position of the knee lifter assembly
according to Fig.3, then fasten rock shaft bracket 7 with
wood screws 6.
B
A
base
table
1
2