typical GC20606-1-D2, Инструкция по эксплуатации

Страница: 6 / 47

11
12
4
13
14
b. When the machine starts for the initial time or resuse
after a long period of time, the proper oil amout should
be filled in sections of machine shown by arrows in Fig
10,11. When it is in operation, observe the oil sparking
in oil screen to check the oil condition (Fig.12).
c. When a new machine starts running, for extending its
life, please run the machine at a low and medium speed
(1000spm) for about a month and then raise the speed
gradually.
d. Please turn off the power when it is not in use or the
operator leaves away from it.
e. Replace the oil every month. When replacing, fully
drain off the old oil in the reservoir and add the new
one.
f. The needle gauge options are: 6.4, 3.2, 4, 4.8, 8, 9.5,
12.7, 16, 19, 25.4mm. For getting it, the needle plate,
presser foot or alternating foot, needle folder, feed dog,
left and right sliding plate, thread guide should be
changed. It is provided with 6.4 mm when it leaves off
the factory. For the other size, the relevant parts can be
ordered from the factory.
4.1 Connecting the power lead
4.1.1 Connecting the power lead
When connecting the power lead to control box, be sure
to confirm the plug model and the matching direction,
then insert the plug into the jack.
If it is three phase power, Connecting "U" to red wire,
"V" to white wire., "W" to black wire. The running
direction of the motor depends on the switch in the
control box.
Note: green wire must be connected to the ground wire
to ensure the motor is connecting to earth.
The capacity of fuse: 200V~240V 10A
120V~120V 15A
4.1.2 Iilluminating line
a. When installing the illuminating lamp (6V,10~15W),
cut off the outside insulating tube of the connector,
which is at the back of the control box, then make the
connection, finally wind some friction tape on the
connector.
Note: Turn off the power when installing the
illuminating lamp.
b. When the illuminating lamp is not in use, the right
side of the lead should take the insulation process as
shown in Fig.14. If it fails, the control box may be
burned out.
4.3 Running direction
Open the rubber cover on the bottom of the left front
of the control box, then press down the direction button
to change the running direction of the motor.
When facing the pulley wheel, and the running direction
is counter-clockwise, the indicator light on the switch
is directing to "off"; on the contrary, to "on". Before
delivery, the running direction of the pulley should be
set as counter-clockwise.
4. Operation
Oil screen
Reverse
feed lever
Operation
Balance wheel
Synchronic belt
Power button
X servomotor
Adapter
Control box
Bare wire
Insulating tape
(2-3 circles wound)
Bare wire
Lead
About 10mm
Lead