TYLZA TYWC100, Инструкция по эксплуатации

Страница: 6 / 16

6
Before Using Your Wine Cooler
 Remove the exterior and interior packaging.

Check to be sure you have all of the following parts:
o 6 Beech Shelves
o
2 Keys
o Stainless Steel Handle
o
Instruction Manual
o 2 Extra Screws for Installing Handle
 IMPORTANT:
Before connecting this wine cooler to a power source, let it stand upright for
approximately 24 hours . This will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
 Clean the interior surface with lukewarm water using a soft cloth.

Install the handle on the left side of the door.
To Install Stainless Steel Handle
1) Pull away the door gasket in the area where the handle is to be installed, as Illustration #1.
The gasket is easily removed by hand, no tools are necessary.
2) Align the handle with the pre-installed screws on the door frame. Tighten the screws with a
screwdriver until the handles secure tightly against the door frame, as Illustration #2. (Do NOT
over tighten as this will cause damage to the handle assembly).
3) Replace the door gasket to its original position.
Note: This wine cooler includes stainless steel handles that are not required to operate this wine
cooler. If you choose not to use the handle supplied, simply follow step 1 to access the
pre-installed screws and remove them and then place 2 decorative plugs (NOT included) into the
two holes separately. Continue on to step 3 to replace the door gasket to its original position.