INSTALLATION AND OPERATING INSTRUCTIONS
4211-861-G 10-12-16 7013545 314 SKSM 211
B
Page 7
WARNING
SECTION 7: T1 CONTROL INSTALLATION & OPERATION
Do not locate benches over
heater. Minimum clearance
of ceiling above heater 44".
Minimum clearance from
heater to wooden surfaces
(benches, side walls, heater
fence etc.) 2 inches.
Mounting brackets supplied.
Provides proper clearance
from wall behind heater.
Use only copper wire of the
size and type indicated in the
Heater Specication Chart
and the temperature rating
indicated on the heater
junction box.
All heaters and controls must
be grounded per NEC to
prevent electrical shock in
case of unit failure.
Electrical outlets or
receptacle must not be
installed in a sauna room.
A guardrail or fence is
required around the heater to
prevent burns from
accidental contact.
INSTALLATION ROUGH IN: Place T1 inside or outside the sauna room. If T1
control is installed inside a sauna room, the top of the unit cannot be higher
than 35 inches above oor.
String low voltage cable through 1" holes in the wall studs or ceiling joists from
the switch location to the heater. Do not use staples to secure the low voltage
cable it may damage the cable! Connect the control wires to the wires in the
wall with the quick couplers. Insert the extra length of wire in the wall.
Remove the adhesive tape from the back of the the T1 Control, place the
control so the hole for the retainer screw is facing downwards, insert control
into the wall and press the contol to the mounting surface.
Power Icon
Timer Icon
Heat Indicator
Home Icon
Back Arrrow Icon
Temperature Icon
Settings Icon
Light Indicator
Time Delay Indicator
Up Arrow Icon
Light On/Off Icon
Ok Icon
Down Arrow Icon
CONTROL OPERATION:
HOME SCREEN: Allows the user to access to time, temperature and other
settings.
BACK ARROW: Allows the user to go back on level in the program.
TURN ON LIGHT: Press the "light bulb" icon once to turn on and press again to
turn off. (Usage of light control is optional)
SET CLOCK: Move your hand in front of the screen. Press "Home" icon and
down" arrow until "SETTINGS" is on screen, press OK. Press "down" arrow
until "SET TIME" is on screen, press OK.
SET TEMPERATURE: Move your hand in front of the screen. Press "down"
arrow until "TEMPERATURE" is on screen, press OK. Press and hold the up or
down arrow until the desired temperature is on screen, press OK.
