2/4
Start the installation under the passenger/right side of
the vehicle and remove the long front, center and rear
body mount bolts, (Fig 1& 2). Do not remove bushings.
STEP 1
Carefully unpack the TYGER Armor and select the
passenger side assembly. With assistance, hold the
TYGER Armor up in place against the bottom of the
body mounts. Reuse the factory body bolts to attach
the TYGER Armor to the body mounts, (Fig 3). Do not
tighten hardware at this time.
STEP 2
Move to the passenger side front mounting location.
Locate the two factory holes in the bottom of the
frame towards the front of the vehicle, (Fig 4). Insert
(1) 10mm Nut Plate into the oval hole and line up the
threaded nut with the forward round hole, (Fig 5).
STEP 3
Front
Factory Body
Mount Bolt
(Fig 1) Passenger/right front body mount
Front
Factory Body
Mount Bolt
(Fig 2) Passenger/right center body mount
(Fig 3) Example rear Bracket Installation
Rear
Locate factory holes
in bottom of frame
(Fig 4) Insert Nut Plate into large slot in frame
Front
10mm Nut Plate
10mm x 30mm Hex Bolt
10mm Lock Washer
10mm Flat Washer
(Fig 5) Line up Nut Plate with small hole in frame
Front
Customer Support: www.TygerAuto.com/Contact
