3/5
Select the driver side Mounting Bracket. Insert the Bracket
through the opening in the bumper, (Fig 5). Trim the plastic as
required to clear the Brackets.
STEP 2
Line up the holes in the Bracket with the holes in the end of the
frame channel for the tow hook, (Fig 6). Select (1) 12mm Double
Bolt Plate, (Fig 7). Insert the Bolt Plate into the end of the frame,
through the (2) holes in the side of the frame and out through the
Bracket, (Figs 8-9). Secure the Bracket to the Bolt Plate with (2)
12mm Flat Washers and (2) 12mm Nylon Lock Nuts. Snug but do
not fully tighten hardware at this time.
STEP 3
Vehicles without Tow Hooks:
a.
Cut out the indented area on both sides of the plastic
bumper insert to clear the Brackets as pictured, (Figs 4-5).
IMPORTANT
: Make several small cuts for best fit. Do not cut
through the top edge of the panel. NOTE: On 2014-15 models,
the plastic panel is held in place with several small screws.
The screws at the top corners are difficult to impossible to
reach and remove without damaging the cover with the
bumper in place. If you prefer to remove the panel to cut out
the openings, it will be easier to remove the bumper assembly
with the plastic panel attached.
b.
Reattach the bumper assembly, (if removed), facia and
grille once openings have been cut out and checked for
clearance. Tighten all factory bumper hardware at this time.
(Fig 4) Example of "no tow hook" model
(Fig 5) Driver side cut out
illustrated for reference only
Fig 7
(Fig 6) Driver side pictured without plastic
panel for instruction purposes only
Mounting holes in end
of frame for tow hook
Customer Support: www.TygerAuto.com/Contact
