Tyco iSTAR eX, Руководство по установке и настройке

Страница: 193 / 232

Displaying Status Messages
iSTAR eX Installation and Configuration Guide 7–3
Displaying Status Messages
Under normal conditions, set the LCD to display status messages, including:
„
iSTAR boot information
„
Date and time
„
Firmware version
„
Controller status information.
Messages typically display for approximately four seconds, separated by an
interval of about one second. In some instances, however, a message can
display until it is cancelled or terminated.
Example:
The Comm Server can display modem dialing information on the LCD for
the duration of the dialing process.
Setting LCD Status Message Display
You can display LCD general status messages for a controller by setting the
SW1 rotary switch to positions 0 (zero) or F. Setting the SW1 switch to 0 or F
also controls the ICU Block feature, preventing or allowing users from
modifying the ICU configuration, as shown in Table 7.1.
„
When ICU Block is On (set SW1 to F) – the LCD displays general status
messages; however, fields in the ICU dialog box are unavailable and
cannot be edited.
„
With ICU Block Off (set SW1 to 0) – the LCD displays general status
messages, and users can read, write, and update the ICU configuration.
Table 7.1: LCD Status Display Messages
Rotary
Switch
SW1 Display General
Messages (Read only)
ICU Block On Display General Messages
(Read/Write/Update)
ICU Block Off
Set SW1 to: F 0