408-4342
PRO-CRIMPER III Hand Crimping Tool Assembly 58603-1
5 of 5
Rev A
Tyco Electronics Corporation
Figure 5
Screwdriver
Ratchet
Adjustment
Wheel
Lockscrew
(Typ)
9. VISUAL INSPECTION
The crimping dies should be inspected on a regular
basis to ensure that they have not become worn or
damaged. Inspect the crimp sections for flattened,
chipped, worn, or broken areas. If damage or
abnormal wear is evident, the tool must be replaced.
See Section 10, REPLACEMENT.
10. REPLACEMENT
Customer–replaceable parts are shown in Figure 1.
Available separately, PRO–CRIMPER III Hand
Crimping Tool Repair Kit 679221–1 includes a
replacement nut and a variety of pins, rings, screws,
and springs.
If the dies are damaged or worn excessively, they
must be replaced.
Order the repair kit and replaceable parts through
your Tyco Electronics representative, or call
1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
11.REVISION SUMMARY
Since the previous release of this instruction sheet,
the following changes have been made:
S
PRO–CRIMPER II Hand Tool became the
PRO–CRIMPER III Hand Tool;
S
The TE logo was applied; and
S
The format was updated to the current
corporate requirements.
