Instruction Sheet
PRO-CRIMPER* III Hand
Crimping Tool Assembly
408-4064
LOC B
1 of 4
E2009 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
04 MAY 09 Rev C
58517-[]
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
The PRO-CRIMPER III Hand Crimping Tool is a Commercial" grade tool
and is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 application specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Tooling Assistance Center at 1-800-722-1111.
Locator
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Die Assembly
Moving Jaw
Ratchet Adjustment
Wheel
Moving Handle
Stationary
Handle
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (Instruction
Sheet 408-9930)
Pivot Pin
Back of Tool
(Wire Side)
Stationary Jaw
PRO-CRIMPER III
Die Assembly
Locator
Contact
Wire
PRO-CRIMPER III
Hand Tool
Die Assembly
Part Number
Locator
Part Number {
Contact
Family }
Size
(AWG)
Insul Dia
(mm {In.])
Strip Length
(mm {In.])
58517-1
58517-2
189590-1
CST 100
26-22
0.89-1.65
2.54-2.92
58517-3
58517-4
1424907
CST 100 II
26-22
[.035-.065]
[.100-.125]
{
Supplied with the die assembly. Also available separately.
}
Contact the PRODUCT INFORMATION CENTER for specific contact part numbers.
{
Figure 1
1. INTRODUCTION
PRO–CRIMPER III Hand Crimping Tool
Assembly 58517–1 consists of Die Assembly
58517–2 and PRO–CRIMPER III Hand Tool Frame
354940–1. See Figure 1.
PRO–CRIMPER III Hand Crimping Tool
Assembly 58517–3 consists of Die Assembly
58517–4 and PRO–CRIMPER III Hand Tool Frame
354940–1. See Figure 1.
The die assembly consists of crimping dies and a
locator assembly.
Read these instructions thoroughly before crimping
any contacts.
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
NOTE
i
