MM-015371-001
6.2 MOUNTING THE CASE AND CASE/ANTENNA BRACKET TO
ADAPTER BRACKET
Mount the motorcycle radio case and the case/antenna bracket to the adapter bracket as follows:
1.
Obtain Motorcycle Radio Case 188D6464P1 (Item 1 in Table 4-1) from Installation Kit MAMV-
NZN7X.
2.
Obtain Case/Antenna Bracket 188D6437P1 (Item 2 in Table 4-1) from Installation Kit MAMV-
NZN7X.
3.
Set the Case/Antenna Bracket onto the
5
/
16
-inch studs of the four (4) resilient mounts. These mounts
were attached to the Adapter Bracket in the previous procedure. Pass the studs through the oval-
shaped holes in the corners of the Case/Antenna Bracket. The bracket’s triangle-shaped antenna
mounting surface must face to the rear of the motorcycle.
4.
Open-up the case to expose the interior floor in its bottom-half.
5.
As illustrated in Figure 6-1, place the case over the Case/Antenna Bracket, and onto the
5
/
16
-inch
studs, passing the studs through the holes in the floor of the case. The square hole in the bottom floor
of the case must be towards the front of the motorcycle, so it is directly over the square hole in the
Case/Antenna Bracket.
6.
Place a 5/16-inch stainless-steel flatwasher onto each of the four
5
/
16
-inch studs protruding through the
holes in the floor of the case. These flatwashers are included in Hardware Kit 350A1396G2 (Item 6 in
Table 4-1).
7.
Add four
5
/
16
-inch serrated nuts to the studs (each nut’s washer side down), and tighten all four nuts
securely. A torque of approximately 100 in.-lbs. (11.3 N.m.) is recommended.
6.3 INSTALLING THE RADIO IN THE CASE
6.3.1
Install the Radio’s Mounting Bracket
Install the radio’s mounting bracket into the weather-resistant motorcycle radio case as follows:
1.
Obtain Radio Mounting Bracket FM103111V1 from Remote-Mount Radio Mounting Bracket Kit
KT23117 (Item 4 in Table 4-1).
2.
If not already, open-up the case to expose the interior floor in its bottom-half.
3.
Position the bracket on the case’s interior floor, at its mounting location. The large notches in the
sides of the bracket must be positioned towards the front of the case. (Some early brackets did not
have these notches.) The square hole in the floor is towards the front.
4.
Secure the bracket to the case’s floor using four M6 x 14 mm bolts and four external-tooth
lockwashers included in Hardware Kit 350A1396G1 (Item 5 in Table 4-1).
5.
Tighten these four bolts securely. A torque of between 55 and 60 in.-lbs. (6.2 to 6.8 N.m.) is
recommended.
31
