408-1559
Hand Crimping Tools
9 of 10
Rev P
Tyco Electronics Corporation
Figure 10
GO" element must pass completely
through the die closure.
NO-GO" element may
enter partially, but must not pass
completely through the die closure.
Detail A
Inspection of Wire Barrel Crimping Dies
Detail B
Inspection of Insulation Crimping Dies
Wire Barrel
Jaws Bottomed
But Not Under
Pressure
Adjustment
Pins in No. 1
Position
4. Check the clearance between the bottoming
surfaces of the crimping dies. If the clearance is
.025 mm [.001 in.] or less, the ratchet is
satisfactory. If clearance exceeds .025 mm
[.001 in.], the ratchet is out of adjustment, and
must be repaired. Refer to Section 8,
REPLACEMENT AND REPAIR. If the tool
conforms to these inspection procedures, lubricate
it with a THIN coat of any good SAE 20 motor oil
and return it to service.
8. REPLACEMENT AND REPAIR
Replacement parts are listed in Figure 11. Parts other
than those listed in Figure 11 should be replaced by
Tyco Electronics to ensure quality and reliability of the
tool. Order replacement parts through your Tyco
Electronics Representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605, or write to:
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
For tool repair service, please contact a
representative at 1–800–526–5136.
9. REVISION SUMMARY
Since the previous release of this sheet, the following
changes were made:
S
Updated document to corporate requirements
S
Added part number 47386–5 to tables in
Figures 1, 3, 8, 9, and 11
