Tomcat i925X S5130
Chapter 2: Board Installation
2-23
http://www.tyan.com
2.12
Installing the Power Supply
There are three power connectors on your Tomcat i925X S5130. By default, the Tomcat
i925X S5130 requires that you have an EPS12V power supply that has a 24-pin and an 8-pin
power connector. However, the Tomcat i925X S5130 is also ATX12V compatible. All 3 power
connectors need to be used if you plan on using the ATX12V power.
Power Supply
Main
power connector
12V
power connector
4-pin AUX
power connector
EPS12V
Required Required
Not
required
ATX12V
Required Required Required
Disconnect power supply from electrical outlet
1.
Connect 12V power connector
2.
Connect 4-pin AUX power connector (required for ATX12V power)
3.
Connect Main power connector
4.
Connect power cable to power supply to power outlet
Note
YOU MUST
unplug the power supply before plugging the power cables to
motherboard connectors.
2.13 Finishing
Up
Before closing up your chassis, make sure that all cables and wires are connected properly,
especially IDE cables and most importantly, jumpers. You may have difficulty powering on
your system if the motherboard jumpers are not set correctly.
If you experience difficulty, you can find help by asking your vendor for assistance. If they are
not available for assistance, please find setup information and documentation online at our
website (
www.tyan.com
) or by calling your vendor’s support line.
