TYAN THUNDER LE-T, Руководство пользователя

Страница: 32 / 63

32
http://www.tyan.com
Step 2: Shown on the right, in Figure 2.4b, is
the 20-pin connector plugged into the board*.
The clip is over the TAB of the onboard
connector.
When you connect the cable into the
motherboard’s 20-pin onboard connector, it will
make a CLICK noise as it is installed.
This is normal.
Figure 2.4b**
Note the TAB
2.25 You are done!
Other than checking the jumper settings and cable connections, and putting the case back
together, you are done.
Installing a new motherboard may seem difficult, but by following these directions, you should
have a fairly uneventful time installing our products. If you do encounter problems, your
vendor/dealer will be able to help you, or you can consult one of our many technical support
solutions (i.e. website or phone).
NOTE
Your ATX power connector may not look like those in the above diagram; they
are used simply as examples.