40
http://www.TYAN.com
There are three power connectors on the Tempest i5000PW S5382.
1 12
13 24
PWR1: 24-pin EPS 12V power connector
+3.3V
1
13 +3.3V
+3.3V
2
14 -12V
GND
3
15 GND
+5V
4
16 PS_ON
GND
5
17 GND
+5V
6
18 GND
GND
7
19 GND
PWR GOOD
8
20 Reset
5VSB
9
21 +5V
+12V
10
22 +5V
+12V
11
23 +5V
+3.3V
12
24 GND
1 4
8
PWR2: 8-pin EPS 12V power connecto
r
(for Memory and MCH)
PWR3: 8-pin EPS 12V power connector
(for CPU)
GND
1
5
+12V
GND
2
6
+12V
GND
3
7
+12V
GND
4
8
+12V
We suggest using a 750W or higher power supply; this is of course dependent on how
many devices you attach. A 750W is sufficient for systems without many devices (i.e. 1
hard drive, 1 optical drive, and 1 or 2 expansion cards) however a higher wattage solution
may be needed if the system is fully loaded. Look to the
www.tyan.com
website for
further information.
NOTE:
The Tempest i5000PW (S5382) peripheral drive power connector must be
independent of any other devices. A device such as a DVD/CD-ROM drive, hard drive, or
any other devices cannot be attached onto the same power line. If connected, system
stability is compromised.
2.33 – Finishing Up
Congratulations on making it this far! You’re finished setting up the hardware aspect of
your computer. Before closing up your chassis, make sure that all cables and wires are
connected properly, especially IDE cables and most importantly, jumpers. You may have
difficulty powering on your system if the motherboard jumpers are not set correctly.
In the rare circumstance that you have experienced difficulty, you can find help by asking
your vendor for assistance. If they are not available for assistance, please find setup
information and documentation online at our website or by
calling your vendor’s support
line.
