http://www.tyan.com
31
ONBOARD
Soft Power Connector
The Soft Power Connector is located on
pins 1 and 2 of jumper block J13. The
Tigercub uses the PIIX4 chip for power
management, including turning on and off
the system. If the Power Button Function
option in the Power Mangement Menu is
set to On/Off (which is the default),
pressing the power button once, after the
BIOS has booted up, will turn the system
on and off. If the Power Button Function
option is set to Suspend, pressing the
power button once will wake the system or send it in to Suspend mode.
In this case, you cannot turn the system off unless you shut down
through the Windows operating system or you hold the power button
down for four seconds.
Speaker Connector Installation
The Tigercub provides a 4-pin header to connect the speaker. The
speaker is connected to pins 24-27 of jumper block J13.
Hardware Reset Switch Connector
Installation
The Reset switch on your case’s display panel provides you with the
Hardware Reset function, which is the same as power on/off. The
system will do a cold start after the Reset button is pushed. The Reset
switch is a 2-pin connector and should be installed on pins 22 and 23 of
jumper block J13.
J13
