13
S1680S-001-02
2.5 Installing Cables and Connectors
2.5.1 Speaker Connector Installation (J45)
Your S1680S board provides a 4-pin header to connect the speaker. The
speaker is connected to pins 24-27 of J45. (Refer to Page 10 and Page 11
for detailed information.)
2.5.2 Hardware Reset Switch Connector Installation (J45)
The RESET switch on your case's display panel provides you with the
HARDWARE RESET function which is the same as power on/off. The
system will do a cold start after the RESET switch is pushed by the user.
The RESET switch is a 2-pin connector and should be installed on pins
22 and 23 on J45. (Refer to Page 10 and Page 11 for detailed information.)
2.5.3 IDE LED Connector Installation (J45)
Your board provides a 2-pin header to connect the IDE LED cable. When
connected, the IDELED light on the panel of the case flashes if an activity
is detected in an IDE device. The cable is connected to pins 15-16 of J45.
(Refer to Page 10 and Page 11 for detailed information.)
2.5.4 Power LED Connector Installation (J45)
The motherboard also provides a 3-pin header to connect the Power LED
cable. When connected, the Power LED light on the panel of the case
indicates power on/off of the system. The cable is connected to pins 18-20
of J45. (Refer to Page 10 and Page 11 for detailed information.)
2.5.5 Infra Red Connector Installation (CON7)
The motherboard provides a connector (CON7) for the Infra Red cable
which connects to a Homing Device on the back of the case. When acti-
vated, the Homing Device will send out IR signals to remote I/O IR de-
vices. (Refer to Page 10 and Page 11 for detailed information.)
