http://www.TYAN.com
19
Power Supply Connection Matrix (w/ 2-rank memory)
Model #
Connector on EPS12V PWR Supply
MB Power Connector
24-pin Connector
PWR1: 24-pin EPS 12V Connector
8-pin Connector
PWR2: 8-pin EPS12V Connector
# 1
8-pin Connector
PWR3: 8-pin EPS12V Connector
Power Supply Connection Matrix (w/ 4-rank memory)
Model #
Connector on EPS12V PWR Supply
MB Power Connector
24-pin Connector
PWR1: 24-pin EPS 12V Connector
8-pin Connector
PWR2: 8-pin EPS12V Connector
8-pin Connector
PWR3: 8-pin EPS12V Connector
# 1
4-pin Connector
PWR4:2x2 pin ATX12V Connector
Disconnect power supply from electrical outlet
a.
Connect the EPS12V 8-pin power connectors
b.
Connect the EPS12V 24-pin power connector
c.
Connect power cable to power supply to power outlet
Make sure you have connected both connectors before attempting to apply
power to the board.
* w/ 4-rank memory: please connect all the 4 power connectors before connect power
cable to power supply to power outlet.
NOTE:
We suggest using an 850W or higher power supply; this is dependent on how
many devices you have installed. We suggest using a 1620W or higher power supply
to support a 8-way system (S4985+M4985).
For 4-rank memory support, please
contact Tyan technique support for related power consumption table.
2.11 – Finishing up
Congratulations on making it this far! You’re finished setting up the hardware aspect
of your computer. Before closing up your chassis, make sure that all cables and wires
are connected properly, especially IDE cables and most importantly, jumpers. You
may have difficulty powering on your system if the motherboard jumpers are not set
correctly.
In the rare circumstance that you have experienced difficulty, you can find help by
asking your vendor for assistance. If they are not available for assistance, please find
setup information and documentation online at our website or by
calling your vendor’s
support line.
