Ref. TinyomII_Quick guide_v03
du
08/12/15
4
7
TINYOM II Power Down
8
Restart the TINYOM II
SPP Slave connection
- On a PC, tablet, smartphone do a Bluetooth device research and connect the
Tinyom II. Tinyom II is named
SW61B
-xxxxxxxxxxx
.
- When the Tinyom II is connected, the
blue
led is ON constantly.
- Set the default settings (see end of doc).
On a PC, tablet, smartphone do a Bluetooth device research and pair the Tinyom II.
Tinyom II is named
SW61B
-xxxxxxxxxxx
.
- Write the pin code «
0000
»
.
The connection is not complete yet. A serial connection should still be made. The
blue led will then light up.
Power down will occur automatically in the following cases:
-
If Bluetooth connection is without activity during one hour (default parameter).
-
If there is not Bluetooth connection during 5 minutes (default parameter).
-
By reading the barcode below.
Green
led
Red
led
> 80%
ON
OFF
40% à 80%
Flashing
OFF
20% à 40%
Flashing
Flashing
4% à 20%
OFF
Flashing
<= 4%
OFF
ON
Press the sensitive sensor for 1 second. 2 beeps indicate the power up of the scanner.
During the 8 seconds startup, the
Green
and
Red
leds give the charge level of the
battery pack.
Default factory settings
Parameters and guidance of uses are details in the
User Manual. Refer it for all others information.
