Installation Requirements
12
Installation
(X505205CP, X505215CP)
Identify all components are present prior to
starting the installation.
1. Slide the plinth onto the threaded tail and
fit the tap body to the basin / bath.
2. Slide the washer onto the threaded tail
and secure the tap to the basin / bath by
tightening the backnut. A suitable
spanner may be required to fully tighten
the backnuts.
3. Connect the hot and cold water supplies
to the threaded tails using either a ½” or
¾” BSP connector or preferably an
isolation valve for future servicing
convenience (not supplied).
4. Turn on water supplies and turn both
taps to the on position, letting the water
flow for a few minutes and purging all air.
5. Check all joints and connections for any
leaks.
Basin & Bath Pillar Taps
IMPORTANT - PLEASE READ
This product has been tested to the Water Regulations Advisory Scheme (WRAS) and satisfies the
requirements of the Water Supply (Water Fittings) Regulations 1999 and current bylaws.
For full Installation Requirements & Notes (IRN) please visit www.wras.co.uk/directory.
Washer
Backnut
Drawings for illustration purposes only
Plinth
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - [email protected]
