TWM P-51D Strega-40, Инструкция по эксплуатации

Страница: 4 / 16

P.3
Main Wing
1
Aileron Pushrod & Retractable Landing Gear
2
PB2x18mm
Screw
4
Ø1mm pilot holes for World Models horn are pre-drilled.
Please look for pin-hole marks at under side of control surfaces.
Straper
Fuel Tube
D6x5mm
PB2x18mm
PB2x14mm
Clevis
Tri-horn
M3 x 14mm
Pushrod
Ø1.8x95mm
Fuel Tube
D6x5mm
PB2x14mm
Screw
2
PWA2.3x8mm n
Screw
8
1.5mm
PWA2.3x8mm
1.5mm
Servo wire
Wing Joiner
Please dry fit wing joiner into left and right wing to make sure they fit with the
proper dihedral angle, mark the wing joiner if necessary. Apply epoxy glue to
both sides of all surfaces in contact. Use a stick to apply the glue to inner side
of wing joiner sleeve, and apply the glue to wing joiner before putting them
together. Wing joiner not glued properly will lead to wing failure and plane crash.
Apply instant type CA glue to both sides of each hinge.
4.8V - 6.0V operation
only, higher voltage
will burn out the
retract motor.
Electric retract wire
PWA2.3x8mm
Bottom View
Bottom View
A341PO31811702