4
heLICOpTeR ChARGING INSTRUCTIONS
Note: Charge the onboard battery before using your Ninja for the first time.
1� Make sure the helicopter and transmitter are both turned off
2� Pull out the charging lead from under the cover on the front of the transmitter�
(Pic�1)
3� Carefully insert the plug into the bottom of the helicopter ensuring it is the correct
way around� (Pic�2) You should not need to force it�
fORCING The ChARGe pLUG IN The WRONG WAY AROUNd
MAY dAMAGe The fLIGhT bATTeRY OR eLeCTRONICS.
4� Set the ON/OFF Switch of the remote control to ON� (Pic�3)
5� The charge indicator on the transmitter will glow GREEN� (Pic�4)
6� The battery is charged when the green charge indicator stops glowing�
7� Set the ON/OFF Switch of the transmitter to OFF�
8� Disconnect the charge lead and stow it away under its cover�
pRepARING fOR fLIGhT
TURNING ON
1� Before setting the ON/OFF switch of the transmitter to ON, make sure the throttle
stick is down, in its lowest position, that is towards you� (Pic�1)
2� Set the ON/OFF switch of the transmitter to ON� (Pic�2)
Note: Always turn your transmitter ON first, then your helicopter.
3� The LED above the ON/OFF switch will glow RED� (Pic�3)
4� Set the ON/OFF switch of the helicopter to ON� (Pic�4) The LED spot light on the
nose will glow white and the RED LED will initially be solid red, then will begin
flashing 3 times in quick succession� When this happens the helicopter is ready
to fly�
5� Place the helicopter on the ground with its tail facing towards you� (Pic�5)
6� Make sure you have a clear indoor space of at least 3 metres wide and two
metres high when you are learning to fly�
Throttle stick
down
ON/OFF switch
to ON
LED will glow
RED
Heli ON/OFF
switch to ON
Heli tail
towards you
