www.tsicustomerservice.com
A576
13
Part
Part Name
Part Number
1
Remote Control
P115
2
Flame Circuit Board
Y15-C73-P40
3
Blue Flame Circuit Board
Y15-C70-P40BL
4
Flame Generator Drive Motor
P10-6-Q
5
Thermostat Sensor
INS-NTC
6
Heater/Blower Assembly
Y15-C72-P01
7
Control Panel Circuit Board
Y16-C86-P32
8
Front Panel With Frame
Y15-S145-P27
9
Emberbed with Log
Y15-S145-P02
10
Emberbed Circuit Board
Y15-S145-P44E
11
Main Circuit Board
Y15-C70-P15
Note:
Battery disposal
Please always dispose of batteries
at a suitable recycling point.
AAA
1.5V
AAA
1.5V
FCC/IC INFORMATION
BATTERY REPLACEMENT
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
· For best results, use 2pcs AAA alkaline batteries.
· Install only new batteries of the same type in your product.
· Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten the life of the
batteries or cause batteries to leak.
· Do not mix old and new batteries.
· Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries.
· Danger of explosion if battery is incorrectly replaced.
· Do not ingest batteries.
Batteries should be recycled or disposed of as per state and local guidelines.
