TVU One TM1000 v2 in V6.0 Set Up and Operating Guide
Page 38 of 49
Setting Ethernet IP Connection via Command Text
The TM1000 v2 gigabit Ethernet interface can also be configured via command text. By
default the eth0 interface will attempt to lease an IP address through DHCP and no fur-
ther action will be required. If a static Ethernet address is required, follow these steps.
A.
Start at the menu commands screen.
Figure 40 Command Display
B.
Type SETIP on the "Enter Command" prompt and press Enter.
Figure 41 Set IP Display
C.
During the configuration script hitting enter will accept the existing value or de-
fault. Hit enter to accept NIC name eth0.
Enter IP address
Enter subnet mask
Enter default gateway
Enter DNS server IP address
D.
The next screen shows the status of your connection.
If the configuration was
done correctly, your entered information should appear under the New Config
portion of the screen (The red arrows in the image below indicates where to
check for your entered information):
