Package
Overview
Installation
1
2
3
4
*
1 It
is
recommended
to
install
the
security cap
for
outdoor installation
.
*
2
If
the PoE switch
is
used
to
power
the
camera
,
DC12V
power supply
is
not
required
.
①
Loosen
the
nut
from
the
main
element.
②
Run
the
network
cable (without
RJ 45
connector) through the
both elements. Then
crimp
the
cable
with
RJ 45
connector
.
③
Connect
the
cable
to
the
hermetic
connector
.
Then
tighten
the
nut
and
the
main
cover
.
Warning
and
Caution
■
If the product does not work properly, please contact your dealer
or the nearest service center. Never attempt to disassemble the
camera yourself. (We shall not be responsible for any problems
caused by unauthorized repair or maintenance.)
■
Do not allow water or liquid intrusion into the camera.
■
In the use of the product, you must be strict compliance with the
electrical safety regulations of the nation and region. When the
product is mounted on wall or ceiling, the device shall be firmly
fixed.
■
Do
not
use
camera
beyond
specified
voltage
range
.
■
Do not drop the camera or subject it to physical shock.
■
Do not directly touch the camera when installing.
■
Avoid touching the camera lens.
■
If cleaning is necessary, please use clean cloth to wipe it gently.
■
Do not aim the camera at the sun or extra bright place.
■
Do not place the camera in extremely hot, cold (the operating
temperature shall be -30˚C~60˚C), dusty or damp locations, and do
not expose it to high electromagnetic radiation.
■
To avoid heat accumulation, good ventilation is required for
operating environment.
Quick
Start
Guide
Network
Camera
Camera
Quick
start
guide
CD
Plastic
plug
×4
Drill
template
Rubber plug
Screwdriver
Tapping screws × 4
Ethernet connector
Audio input connector
Alarm input/output
Power
connector
Reset
Please make sure that the wall or ceiling is strong enough to
withstand 3 times the weight of the camera. Please install and use
the camera in the dry environment. You'd better install back the lower
dome less than 4 hours after removing it. Do not remove the protection
film until finishing the installation.
①
Attach the drill template to the place where you want to fix the camera
and then drill the screw holes and the cable hole on the wall according
to the drill template.
2
1
3
Micro SD Card Slot
Securi
ty Cap
■
Please read this instruction carefully before operating the unit
and keep it for further reference.
■
All the examples and pictures used here are for reference only.
■
The contents of this manual are subject to change without
notice.
74.3
74.3
1
2
3
4
5
6
(mm)
1
2
3
4
5
6
DC12V
A
L
A
R
M
4 3 2 1
A
L
A
R
M
4 3 2 1
1--ALM-COM
2--ALM-OPEN
3--ALM-INA
4--ALM-GND
●
Connecting
Network
Cable
●
Alarm Input
: Join the grounding ends of the sensor and the camera and then
connect the signal cable of the sensor to the alarm input port (ALM-INA)
of the camera.
Alarm Output
: Loosen the screws in the alarm output port. Then insert the
signal wires of the alarm output devices into the port of OPEN and COM
separately. Finally tighten the screws. Some of the external alarm output
devices need the power supply.
Alarm Connection
