TVS RONIN, Руководство пользователя

Страница: 93 / 127

90
B
0.8 ~ 0.9 mm
A
SPARK PLUG
1. Wipe and clean the dust and mud around the
spark plug mounting to avoid their entry inside
the cylinder.
2. Pullout the suppressor cap from spark plug.
3. Remove the spark plug using a plug spanner.
A spark plug with heavy carbon deposits will not
produce strong sparks. Hence, only if necessary,
remove the carbon deposits from the spark plug with
a small wire brush or spark plug cleaning tool.
Inspect the spark plug electrodes (A) and (B) for any
corrosion. If found any replace the spark plug with a
new one.
Visually inspect the spark plug gap. The gap should
be 0.8 to 0.9 mm. If the gap is found to be more,
replace the spark plug with a new one.
After cleaning and inspecting the gap, reinstall
the spark plug and tighten by hand to avoid cross
threading. Finally tighten using the spanner. Do
not over tight or cross thread the spark plug. After
reassembling the plug fix back the suppressor cap
and ensure its proper fitment.
Always use only recommended make and type of spark
plug. Since the hook type spark plug is used, it is not
advised to adjust the plug electrodes as it may damage
the electrodes. Replace spark plug every 12000 km or
1 year whichever is earlier.
Cover the spark plug hole with a cloth when the plug is
removed to prevent entry of dust / water.
Do not remove the spark plug when the engine is hot. It
is advisable to tight the new spark plug by hand till the
end and then loose. Again re-tight the spark plug by 1/8
of rotation after sealing by using only the hand tool.
Caution