49
49
Check for the wear of brake pads visually. If the brake
pads wear is found beyond the wear indicator groove
as shown in the figure, replace the brake pads as a
set with a new one.
Rear brake
1. Measure the free play of the rear brake lever at
the lever end as shown in the figure.
4. The brake fluid level always should be above
the ‘MIN’ mark (B) provided on the view piece
glass of the master cylinder when the cylinder is
parallel to ground.
5. If the brake fluid level is below the ‘MIN’ mark or
while applying brake if you feel the brake is more
spongy or ineffective due to air entry and if any
rattling play is observed in both the brake levers,
contact TVS Motor Company Authorised Main
Dealer or Authorised Dealer for topping-up the
brake fluid, air bleeding and other brake related
inspections.
Brake pad wear indicator (Disc brake)
Wear Limit
10 ~ 15 mm
Please remember that the rear brake lever free play
adjustment to be done only after adjusting the front
brake lever play.
Note