Setting up a second display
If your output module has more than one output port, you can add a second display. CORIOview™ clones your
output onto your second display. Both displays show the same output at the same resolution.
Read more about output resolution
To clone your output to a second display
1. From
Dashboard
, select
.
2. From
Properties
>
Clone Output
select
On
.
Setting an output resolution for your display
If you have more than one display, your output is cloned onto the second display. Both outputs have the same resolution.
Before you set an output resolution for your display, make sure you have either loaded the configuration from
your CORIOview™, or created an offline configuration.
Read about getting the configuration from your CORIOview
Read about creating an offline configuration
To set the output resolution of your display
1. From
Dashboard
, select
.
2. From
Properties
, select a resolution for your display.
If you have more than one display, select a resolution appropriate for your primary display.
PDF-MWP-DYN-V1.20 tvONE
31