Tvone 1T-DA-552, Инструкция по эксплуатации

Страница: 8 / 12

6
1T-DA-564 1x4 DVI DA with Audio
4.1 Connecting the Inputs to the Distribution Amplifiers
You can connect any DVI compliant device’s output to the DVI input. Make certain that
the DVI cable is securely plugged into the source device as well as the DVI Distribution
Amplifier. Always use a high quality cable, as short a length as possible, for best results.
4.2 Connecting the Outputs to the Destination Devices
Using a high quality DVI cable, connect each output of the DVI DA to a DVI compliant
device. Use the shortest cable run possible.
4.3 Connecting the Audio I/O (1T-DA-564 Only)
Connect S/PDIF audio from the source device to the 1T-DA-564’s S/PDIF input and
then connect the S/PDIF outputs from the 1T-DA-564’s RCA connector(s) to the
destination devices. If the destination devices can accept only analog stereo audio,
connect stereo audio to the 1T-DA-564’s input and then to the device’s inputs using the
3.5mm connectors.
4.4 Connecting Power
All units are shipped with a Power Adapter to convert 100~240VAC@50-60Hz to 5VDC.
Connect the DC Output Cable from the Power Adapter to the back of the unit and then
plug the Power Adapter into an AC Receptacle. There is no power switch. The unit
begins to function as soon as it is plugged into AC.
4.5 Optional Rack Mount Kit
The Distribution Amplifiers can be mounted in a standard 19” equipment rack. To
mount either of the 1x4 DAs in a rack, the optional RM-220 Rack Mount kit must be
purchased. Using this kit, either type DA (Video only or Video + Audio) can be mounted
in the rack. It’s also possible to mount one of each DA in the rack using the dual rack
mount capability. It is not necessary to mount two of the same type of DAs.