Tvone 1T-DA-124, Инструкция по эксплуатации

Страница: 7 / 10

5
4.0 CONNECTING THE HARDWARE
Connect the Analog Audio source and/or S/PDIF audio source to the input(s) of
the 1T-DA-124, connect its outputs to an appropriate audio devices or audio
equipped monitors and lastly connect the AC to DC Power Adapter. The drawing
below shows the locations of the inputs, outputs and power connector.
1T-DA-124 DA
4.1 Connecting the Inputs to the Distribution Amplifiers
You can connect either analog stereo or S/PDIF coaxial audio to the 1T-DA-
124’s inputs. It’s possible to distribute analog stereo and S/PDIF audio at the
same time or just one type of audio. Make certain that the cables are securely
plugged into the devices as well as the Distribution Amplifier. Always use high
quality cables, as short a length as possible, for best results.
4.2 Connecting the Outputs to the Destination Devices
Using high quality cables, connect each output of the DA to an appropriate
destination device. Use the shortest cable run possible.
4.3 Connecting Power
All units are shipped with a Power Adapter to convert 100~240VAC@50-60Hz to
5VDC. Connect the twist lock DC Output Cable from the Power Adapter to the
back of the unit and then plug the Power Adapter into an AC Receptacle. There
is no power switch. The unit begins to function as soon as power is available.
4.4 Optional Rack Mount Kit
The Distribution Amplifiers can be mounted in a standard 19” equipment rack.
To mount the 1T-DA-124 DAs in a rack, the optional RM-220 Rack Mount kit
must be purchased.