TVLogic LQM-241W, Руководство по эксплуатации

Страница: 9 / 36

Multi Format LCD Monitor 9
3. Controls & Functions
FRONT
̻
[ANALOG] Button/Lamp
- Used to select the desired Analog input and
DVI input. Press the button to activate the
analog input menu selection, then use UP and
DOWN button to select desired input.
* See section “Other Functions [1]ANALOG
Button” for more information.
̻
[MODE] Button/Lamp
- Used to select single SDI input.
- Press the button to activate the modes. The
mode is changed as the following sequence :
SDI-A => SDI-B => SDI-C => SDI-D.
̻
[QUAD] Button/Lamp
- Used to select multi display.
- Press the button to activate the modes. The
mode is changed as the following sequence:
QUAD => 2P:2W => 1P:2W => 1P:2P => 1P:3P
=> QUAD
* See selection “ Other Functions [3] QUAD
Button” for more information.
̻
[SCAN] Button/Lamp
- Used to change the Scan mode.
- The mode is changed as the following
sequence.
- Single Display: OVER SCAN -> ZERO SCAN ->
UNDER SCAN -> 2:1 SCAN -> 1:1 SCAN -> FIT
WIDTH -> USER ASPECT
- Multi Display: Available modes are OVER
SCAN and ZERO SCAN.
* See section “Other Functions [4]SCAN
Button” for more information.
̻
[ASPECT] Button/Lamp
- Used to change the display ratio between
4:3 and 16:9.
- Display ratio is fixed to 16:9 if the display
ratio of input signal is 16:9.
* See section “Other Functions [5] ASPECT
Button” for more information.
̻
[MARKER] Button/Lamp
- Used to activate or inactivate the marker.
- The desired aspect ratio can be displayed on
the screen properly when the type of marker
selected from the main menu.
- If AFD is selected on the main menu, marker
automatically activates when input signal
contains the embedded AFD data.
̻
[H/V DELAY] Button/Lamp
- Used to check horizontal sync and vertical
sync simultaneously by moving the display to
the left, right, up and down.
- In this mode, the brightness of image
automatically increase for easy verification of
synchronized signals.
̻
[BLUE ONLY/MONO] Button/Lamp
- Used to activate MONO mode or remove red
and green from the input signal and display
the screen only under a blue signal.
Press the button to activate blue only mode
and press again to activate mono mode.
- This mode does not activate in RGB, DVI
ANALOG, DVI DIGITAL and HDMI modes.
̻
[CHROMA/PHASE] Button
- Used to activate CHROMA, PHASE and
Closed Caption features when the OSD menu
is not activated. Use UP/DOWN button to set
the value.
- Activates in the order below
- SDI-A/B modes : CHROMA -> Closed Caption.
- Component mode : CHROMA.
- Composite/S-Video modes : CHROMA ->
PHASE -> Closed Caption.
- DVI-Analog mode : PHASE.(AUTO PHASE)