Tuxedo MR6K-48X, Руководство по установке и эксплуатации

Страница: 11 / 17

11
MR6K-48X
Dec 2017
5. Position the Arms outward and position the Saddle Pads to contact the vehicle lifting points.
6. Do not lift the vehicle if you cannot establish secure and level lifting points. Do not use sub-standard
shims or other devices in place of approved and recommended Saddle Pad Adapters. Never use the
Lift without the Saddle Pads in place for each Arm.
7. Once the Saddle Pads have been positioned under the vehicle lifting points, push the Power Unit
Switch to lift the vehicle slightly, and test to make sure the vehicle is well balanced and the contact
between the Saddle Pads and vehicle’s lifting points are secure. Then, proceed to lift the vehicle to the
desired height.
8. When the vehicle has been lifted to the desired height, and the Safety Lock Assembly has locked in
place, make sure to install proper safety jack stands (not included), under the vehicle once it is lifted to
the desired height, as an additional safety measure.
9. Once the repair work to the vehicle is completed make sure to remove all tools, safety jack stands, and
materials form under the vehicle and Lift. Also, make sure the work area is clear and it is safe to lower
the vehicle.
10. To lower the Lift, use the Power Unit Switch to slightly raise the vehicle to remove pressure off the
Safety Lock Assembly.
11. Stand well away from the Lift and vehicle. Then squeeze and hold in the Hand Lever while at the same
time pushing in and holding the Pressure Relief Valve Handle to slowly lower the Lift all the way down
to the floor.
12. Move the Saddle Pads and Arms inward, out of the path of the vehicle.
13. Disengage the vehicle parking brake. Start the vehicle's engine, and carefully drive the vehicle off the
Lift slowly.
Inspection, Maintenance & Cleaning
Always unplug the Power Cord from the electrical outlet before performing any
inspection, adjustments, maintenance and/or cleaning.
BEFORE EACH USE: Inspect the general condition of the Lift. Check for loose screws, misalignment
or binding of moving parts, broken parts, damaged electrical wiring and hoses, and any other condition
that may affect its safe operation. If abnormal noise or vibration occurs, have the problem identified and
corrected before further use. Do not use a damaged equipment.
DAILY: With compressed air or vacuum, remove all dirt and debris from the Lift. Also, use a detergent
or mild solvent to remove oil and grease from the unit. Then, use a premium quality, machine oil to
lubricate all moving parts.
MONTHLY: With the lift fully lowered, check the level of hydraulic oil in the Reservoir Tank is close to
the Max Fill Line. If not, remove the Fill Cap and add premium quality hydraulic oil until the level of oil
is even with the Max Fill Line. After filling, place the Fill Cap to Reservoir Tank.
Never Add Hydraulic Fluid while Lift is in raised position!!