Tutondo PQV482, Инструкция по эксплуатации

Страница: 13 / 16

593
13
Rear Panel Layout
1 1 4 5 4 5 6 8 10
2 3 6 7 8 9 10 11 7 9 11
1. AC FUSES
Replace fuses with the same models if interrupted.
2. AC POWER INPUT SOCKET
(230VAC, 50Hz)
3. GROUND CONNECTION SCREW
4. DC POWER SUPPLY TERMINALS
These terminals are used for connecting a 24VDC secondary power supply (i.e. from batteries). Please ensure correct polarity
5. SPEAKER OUTPUT TERMINALS
The terminal connection can connect low impedance 8 ohm, or high-level 70V or 100V speakers. Use only one of these output
connections for corresponding speakers.
6. JACK 6.3mm OUTPUTS
Connect output jack to other amplifier by using phone jack cable.
7. XLR OUTPUTS
Connect output XLR to other amplifier by using XLR cable (Pin 1 = Shield, Pin 2 = hot, Pin 3 = cold).
8. PARALLEL/MONO SWITCHES
Put the switch on MONO position when it does not connect other amplifier. When it is connected to other amplifier, put the switch
on PARALLEL position to maintain maximum gain.
9. GAIN CONTROLS
Turn it clockwise to adjust the output level of the amplified signal.
10. XLR INPUTS
Connect signal source to XLR input by using XLR cable (Pin 1 = Shield, Pin 2 = hot, Pin 3 = cold).
11. JACK 6.3mm INPUTS
Connect signal source to input jack by using phone jack cable.