Cleaning and Special Maintenance
Filter Assembly
For the best performance and results, the filter assembly must
be keep clean.
The filter removes food particles from the wash water, allowing
the water to be recirculated during the cycle. For this reason, it is
a good idea to remove any food particles trapped in the filter
after each wash cycle by rinsing the semi-circular filter and cup
("A") under running water. To remove the filter assembly, pull
the handle in an upward direction. The entire filter assembly
(made up of the semicircular filter "A" and the fine filter "B")
should be cleaned at least once a month use a soft brush. To
reassemble, insert the entire assembly into the dishwasher, lo-
cate it correctly in its seat and pressing downward.
The dishwasher must not be used without the filters. Improper
replacement of the filters may reduce the performance of the
appliance.
Cleaning the Spray Arms
Food particles may become encrusted on the spray arms and
block the hole (see "Close up view [interior]" on page 3, letters
C-E ). Check the spray arms periodically and clean them when
needed.
If the dishwasher does not function or does not function correctly,
check the following before calling for assistance.
The Dishwasher Does Not Start
- Is the plug pushed into the socket correctly?
- Is the power on in the house?
- Is the door closed properly?
- Is the Power switch "ON"?
- Is the water supply turned on?
The Dishwasher Does Not Fill with Water
Have you checked whether:
- the water is turned on and the hose is connected properly;
- the water supply to the houses on and has sufficient pressure;
- the water supply hose is crimped or bent;
- the filter for the water supply hose is clogged.
The Dishes Are Not Clean
- Is the drain hose kinked or bent?
- Has the detergent been dispensed?
- Are the spray arm holes blocked?
- Are the spray arms rotating?
The Dishwasher Does Not Drain
- Is the drain hose kinked or bent?
Lime Deposits or a White Film Form on the Dishes
- Is the rinse aid dosage is correct?
If, despite all these checks, the dishwasher still does not func-
tion and/or the problem persists, contact your nearest authorised
service centre and provide them with the following information:
- The nature of the problem;
- The model number (Mod...) and the serial number (S/N...),
which are located on the side of the inner part of the door.
Troubleshooting
A
B
Cleaning the Water Inlet Filter
Clean the water inlet filter located in the inlet hose where it screws
onto the tap.
- Turn off the water tap, unscrew the hose, remove the filter and
clean it carefully under running water. Then refit the filter and
tighten the hose back into position on the tap.
.8.
