Tusa SAV-7 EVO2, Инструкция по эксплуатации

Страница: 15 / 32

CAUTION
●
Never jump into the water with scooter from a boat or any other elevated location.
Never throw the scooter, as it is potentially very dangerous. Please refer to the boat entry method for further
instruction.
CAUTION
●
Please turn off the main switch so that the propeller cannot operate by mistake when passing it to a diver.
●
Do not enter from a boat or other elevated position while holding the scooter.
Don't jump from a high place with the scooter
Do not enter the water while holding the scooter Please turn off the main switch
Moving along the surface ! Waist deep
・・・
or underwater !
Don't throw the scooter
■
STEP1 Entry from shore.
■
STEP2 Entry from boat and other elevated areas.
■
STEP2 Boat
■
STEP1 Beach
The scooter is very light when in the water - just slightly negative. While hands free riding it's very easy to use the
scooter in shallow water even up to waist deep. You don't need to stay on the bottom in shallow water.
You can enjoy cruising along the surface quite comfortably until you find a deeper area you would like to dive to.
●
Please secure the scooter by a lanyard or rope in the water or hand it to the diver after he or she has entered the
water.
●
When passing the scooter to a diver already in the water please lower the scooter in so the diver can easily grasp
a handle or grip.
Its recommended to drive the scooter up to waist deep water and leave it close to or on the edge the shore.
The scooter is heavy when out of water. It is strongly recommended that you remove your diving equipment on
the shore prior to lifting the scooter.
Securely attach the scooter with a rope or lanyard to the boat.
Lift the scooter from the water after the diver has exited.
Entry method
Exit
18
CAUTION
●
If the motor has stopped please carefully check for debris that may be obstructing or entangled in the propeller
area. Please ensure the debris is completely cleared away prior to resetting and reactivating the motor otherwise
damage may occur.
TUSA underwater scooter has a built-in safety device that protects the motor if overloading occurs.
For example if rope gets wound around the propeller shaft the scooter will automatically stop.
The scooter safety sensor protects the diver's safety from rotation rebound if the propeller becomes entangled or
otherwise obstructed.
The scooter is equipped with a safety sensor to protect the motor from burn out and deterioration caused by
overloading.
If the safety device is activated, turn off the main switch once and it will be reset.
After resetting, the motor should works as usual.
TUSA underwater scooter speed is controlled by the rotational speed of the propeller with the accelerator unit
and by adjustment of the propellers pitch. The rotational speed of the propeller rises when the accelerator lever is
pulled up. The rotational speed decreases when the accelerator is pushed down.
■
STEP1 Accelerator operation
How to operate.
Pull out accelerator Push down accelerator
Overload protection safety sensor
14